4″–12″ Heavy Duty Gate T Hinges

Worked good

The metal is much thinner than a heavy duty hindge.

These hinges are well made. They worked nicely supporting a couple of 7’ high x 8’ wide wooden doors I built for a shed.

As long as you don't expect much for the money these are a good buy. At less than half the cost of home improvement store for an 8" hinge these are exactly that. They are not a heavy duty more a standard duty hinge. I'll be using three of them on each of a pair of 55 x 60 gates associated to a 10ft RV pad entrance. These do not have plastic bushings at the pivot point so they will squeak and will require lubrication. The included fasteners are inadequate, but I'll use them for another purpose. The hinge mounting through holes will accommodate 1/4" lags. Three of the six needed some straightening using a vise because they would not sit flat. The gates are currently mounted with two 4" hinges and sagging. I do not have a picture of this project because I am still assembling the new 2x4 gate frames. I am of the perception most know what hinges look like when mounted.

I would not say these qualify as heavy DUTY I didn’t use them and waited to long to return. But suppler was prompt and shipment was complete.

They are holding on good. The fence is about 200 pounds and I haven't seen it sag at all. Great hinge quality.

Typically a hinge is relatively tight fitting and operates smoothly. These have a lot of play in them because the pin is too small for the knuckles, thus the leaves are loose with too much movement.
Great paint job though.

I don't regret my purchase of these hinges, but they don't have bearings, they are not rustproof and definitely not powder coated. I assumed this would be the case at this price point.
They are painted black, but they are prone to chipping.
Take care in hanging them and they will perform just fine.

I like the quality of the black painted, powder coat finish.

Extremely loose hinges, wouldn’t recommend